Loop Control: Next & Exit Statements

The following are two additional statements that can be used to control the looping construct:

Next

The next statement is used to skip the remaining code in the current iteration of the loop and proceed to the next iteration. In a for-loop, the index variable will be incremented or decremented automatically before the next iteration. In a while-loop, this behavior depends on the logic applied. There are two ways to use the next statement.

    next when (condition);
    if (condition) then
        next;
    end if;

Exit

The exit statement is used to forcibly stop the loop. When this statement is executed, the loop will terminate immediately, and the program will continue executing the code that follows the loop. There are two ways to use the exit statement.

    exit when (condition);
    if (condition) then
        exit;
    end if;

Example

Below is an example of a for-loop that uses the next and exit statements.

    process
        variable i: integer := 0;
    begin
        for i in 0 to 7 loop
            if i = 3 then
                next; -- Skip the rest of the code in this iteration
            elsif i = 5 then
                exit; -- Exit the loop
            end if;
            reg(i) <= reg(i+1);
        end loop;
    end process;

This VHDL code snippet demonstrates the use of a for-loop within a process statement. Here's the detailed explanation:

1. Process Declaration:

   • The process block is declared, and a variable i of type integer is initialized to 0.

2. For-Loop:

   • The for-loop iterates over the range from 0 to 7, inclusive. The loop variable i is automatically created and incremented with each iteration.

3. Conditional Statements:

   • Inside the loop, there are two conditional checks:
     • if i = 3 then: If i equals 3, the next statement is executed. This causes the loop to skip the remaining code in the current iteration and proceed to the next iteration.
     • elsif i = 5 then: If i equals 5, the exit statement is executed. This causes the loop to terminate immediately, and the process continues with the code following the loop.

4. Register Assignment:

   • If neither of the above conditions is met, the code reg(i) <= reg(i+1); is executed. This assigns the value of reg(i+1) to reg(i).

5. End Loop and Process:

   • The loop ends after completing the iterations from 0 to 7, unless exited early by the exit statement.
   • The process block ends after the loop.

Summary

• The loop iterates from 0 to 7.
• When i is 3, the loop skips the current iteration.
• When i is 5, the loop exits.
• For other values of i, reg(i) is assigned the value of reg(i+1).